Drape the rain fly over the poles that are standing, matching the red webbing on fly with red webbing onįootprint. Repeat Step 3 with the remaining orange pole and insert the ends into the grommets on the remainingĦ. The pole will wrap around the two hubs.ĥ. Print and the other end into the grommet on the black webbing on the opposite side of the footprint, directlyĪcross from where you started. Insert one end of the straight orange pole into the grommet on the black webbing on the side of the foot So the shorter, middle section is parallel to the side of the footprint that does not have the black webbing straps.Ĥ. Insert the four ends of the hubbed pole into the grommets in the red webbing straps. Assemble the four poles: One orange hubbed pole, two orange straight poles and one black vestibule pole.ģ. The Fast Fly configuration requires the footprint, tent fly, poles and stakes.Ģ. If you purchase the optional Big Agnes footprint for any of our models, it will enable you to pitch a Fast Fly shelter while leaving the tent body behind. Stake out all corners and guy lines for maximum stability, space and ventilation. Clip the remaining buckles on the fly and tent body together.ġ7. Insert the ends of the vestibule pole into the remaining grommets in the red webbing straps at the frontġ6. Then,Īttach the Velcro loops on the underside of the fly to the pole.ġ5. Feed the black pole through the sleeve above the vestibule door on the underside of the fly. Unclipped until the vestibule pole is inserted in front vestibule.ġ4. Clip the rear three buckles on flyĪnd tent body together on each side of tent (one red, two black). There are four webbing straps with buckles on each side of the tent. Webbing on the fly and corners of the tent body together.ġ3. Drape the rain fly over the tent – the door with the vertical zipper will be the back door. Now, attach the carabiner-style clips over both poles where they intersect.ġ2. Attach the hook shaped clips on the tent body to this pole.ġ1. With the seam lines and clips on the tent body). This pole will angle towards and wrap around the back of the tent, above the back door (the pole aligns Webbing straps towards front door of tent body.ġ0. Repeat Steps 7 and 8 with the remaining orange pole, inserting pole into grommets on remaining black Attach the hook shaped clips on the tent body to this pole –īut do not yet attach the carabiner-style clips.ĩ. The seam lines and clips on the tent body). The pole from Step 7 will angle from back to front to back, wrapping around the front of the tent,Ībove the front door and back to the black webbing on the opposite side if the tent (the pole aligns with Larger vestibule on the fly will be the front and the smaller vestibule will be the back. Take one of the orange poles and insert the ends into the grommets on the black webbing straps located at theįloor seam towards the back door of the tent (tent body is symmetrical and you determine the front and back. The hook shaped clips fit over the pole.ħ. Two clips are “u” shapedĪnd slide over the bottom of the hubs. Attach the clips on the tent body to the hub pole frame that is now standing. Insert the four ends of the hubbed pole into the grommets in the red webbing straps at the four corners of the tent.Ħ. Make sure that side of the hub is facing down.ĥ. You will notice one side of each hub has a piece that will fit into the plastic clip on the tent body. The pole with the seams and clips on the tent.Ĥ. Orient the hubbed pole so the shorter, middle section runs across the width of the tent body, aligning One orange hubbed pole, two orange straight poles and one black vestibule pole.ģ. Remove contents of stuff sack and lay tent body flat on ground.Ģ.